Mighty-mule MM600ET-PRO Manual do Utilizador

Installation Manual1. KEEP CLEAR! Gate may move at any time.2. Do not allow children to operate gate or play in gate area.3. This gate is for vehicles

Important Safety Information7Warning signs alert people of automatic gate operation and are required when installing the Mighty Mule 600 Automatic Gat

Important Safety Information8!Product identification label (1) installed on side of control box.AUTOMATIC GATE OPENERMM600ET-PRO®by...LISTEDUSCGates T

Technical Specifications9Mighty Mule 600 Gate OpenerDRIVE•Lowfrictionscrewdrive(linearactuator)ratedfor-5ºFto+160ºF(-20ºCto+71ºC).U

Check Direction of Gate SwingBefore You BeginYour Property Your PropertyIMPORTANT: Check for Proper Gate InstallationEABCDFCheck Existing Gate Size an

Column Installation InformationBefore You Begin3/8” x 1-1/2” Clevis Pin (2)3/8” x 8” Bolt (4)8” Nylon Cable Tie (14)Receiver andControl BoxOperatorArm

x23/8” Bit 5/16” BitDrillPliersLevelClampAdjustableWrenchPenCenterPunchHammerTapeMeasureSmallFlat HeadPhilips HeadScrewdriverFlat HeadScrewdriverWireS

13Mounting Pull-to-Open Opener to GateGate Opener InstallationISVHIRY1XXFMMQBQ2Attach opener to gate bracket and secure with required hardware.Assemb

14261Mounting Pull-to-Open Opener to GateGate Opener InstallationOPEN gate and reattach opener with clevis pin. Check for level. Clamp securely.UOZ7Se

15Mounting Pull-to-Open Opener to GateGate Opener Installation12YSTR112213Attach and secure opener assembly to brackets.Attach gate bracket assembly t

16Assemble post bracket parts. NOTE: A Push-to-Open Bracket FM148 is required for this type of installation (not included).IIRVSYPTOBracketFM14811” 1X

Warning!The Mighty Mule® Gate Opener is intended for use with vehicular swing gates. The opener can be used in Class I, Class II, Class III and Class

CLOSE gate and re-attach opener with clevis pin. Check for level. Clamp securely.162UOZ7Secure post pivot bracket to post bracket when clearance is OK

18Mounting Push-to-Open Opener to GatePush-to-Open InstallationYour Property12YSTR132121Attach and secure opener assembly to brackets.Attach gate brac

1915FUSEBAT T+BAT T-1 2 3 4ON OFFSOFT START OFFWARNING OFFOPEN PULLSLV OPEN DLY.MODE1 OFFMODE2

20FCC RegulationThis device complies with FCC rules Part 15. Operation is subject to the following conditions:1. This device may not cause harmful int

21CAUTION: Please call your power company before you dig. Failure to do so could cause injury or even death.9Top ViewMin 3 FtMax 1,000 FtGTO Transform

2211C11211124” BLK15FUSEBAT T+BAT T-CHARGINGPWR INWHTBLUBRNORGREDBLKGRNWHTBLUBRNORGREDBLKGRNCOMCOMMASTER CABLE2ND CABLEAUTO CLOSE TIME 1 2 3 4 5

24” Feed cable 10” into box.Solar Panel Installation23Winter Ratings Zone 1 Zone 2 Zone 312 v single gate (10 watts) solar charger8 16

24BLK15FUSEBAT T+BAT T-1 2 3 4ON STATUSLEARN RMTRECEIVERLEARNMAST LIMIT LEARNSLV LIMIT OFFSOFT START OFFWARNING OFFOPEN

Control Box SettingsDIP#1ON**___Soft start enabled (factory preset).OFF __Soft start disabled.DIP#2ON**___Buzzer warning enabled (factory preset).O

Setting Pull-to-Open (Closed) Gate Limit (for push-to-open go to pg. 27)ON13212Control Box Settings1 2 3 4ON LEARNMAST LIMIT LEARN2ND LIMIT S3

Table of Contents PLEASE READ THIS FIRST _______________________________________________________ 1IMPORTANT SAFETY INFORMATION _____________________

27With gate in CLOSED position, turn control box power switch to ON.Press button on transmitter; gate should start opening. Press button on transmitte

Turn the “STALL FORCE” arrow in the center of the potentiom-eter with small flat head screwdriver. Adjust the sensitivity from the MINIMUM position up

29Control Box SettingsFCC RegulationThis device complies with FCC rules Part 15. Operation is subject to the following conditions:1. This device may n

30GTO Photo BeamsGTO Loop DetectorMighty MulePush Button ControlAccording toApplicationAccording toApplicationMighty MuleVehicle SensorRefer to Vehicl

31Connecting Additional Devices1 COM: Circuit common (reference for all logic input) •Two(2)terminalstoprovideextracommonconnectionpoint.2

32Maintenance & Troubleshooting•Onallgatesweighing250lb.ormore,routinelygrease the ball bearing hinges at least 4 times a year; more fr

Audible FeedbackSymptom Diagnosis Check:1 short beep upon activationBlown FuseLow or Bad BatteryLoose Battery Connection•Fuses - control board and

34Visual FeedbackSymptomDiagnosis Check:Status (clear)1 blinkCycle Terminal ShortedDisconnect the push button, keypad, intercom keypad, or any otherac

35Repair Service1. First use the procedures found in the Maintenance & Troubleshooting Guide (see page 33). 2. For 24 hour 7 days a week troubl

36For Your RecordsPlease record the product serial number (located on the right hand side of the control box), and the date and place of purchase in t

1Please Read This First!Thank you for purchasing a Mighty Mule® E-Z Gate Opener—GTO's "do-it-yourself" automatic gate opener! When corr

Accessories are Available From Your Retail Store®E-Z GATE OPENERSACCESSORIESAUTOMATIC GATE LOCK®ELECTRONIC SECURITY LOCKSolar Panel (FM121) The Solar

38If you have a question about any special order item, just call 1-800-543-GATE!Accessories are Available From Your Retail Store (con't)The conte

®E-Z GATE OPENERS3121HartseldRoad•Tallahassee,Florida,USA32303TelephoneGTOSales:1-800-543-GATE(4283)or(850)575-0176•Fax(850)575-891

Important Safety InformationClevis PinHairpin ClipGate BracketFront MountBushingBecause automatic gate openers produce high levels of force, consumer

Important Safety Information3 1. READ AND FOLLOW ALL INSTRUCTIONS. Failure to meet the requirements set forth in the instruction manual could cause

Important Safety InformationMoving GateAreaDriveway10'10'10'10'NEVER installany control devicewithin gray area4II. During Installa

Important Safety Information5III. After Installation 1. Attach the warning signs (included) to each side of the gate to alert the public of autom

Important Safety Information6As specified by Gate Operator Safety Standard, UL 325 (30A.1.1), automatic gate operators shall have an inherent entrapmen